how to open csv and plot contour data
6 views (last 30 days)
Show older comments
I have a large .csv data file from a measurement sensor, i want to open the file and plot the data using Matlab. The data is in contour format, such that each row is a line scan of (X) points. At the start and end of each line (row) there are "junk" values of -999.999 where nothing was measured i'd like to filter these values out also.
I'm a newb to this so any help would be appreciated.
0 Comments
Accepted Answer
Star Strider
on 16 Aug 2018
Edited: Star Strider
on 16 Aug 2018
Example —
D = rand(100);
figure
contour(D)
To eliminate the ‘-999.999’ values, replace them with NaN values, since those will not be plotted (and likely will appear a white blank areas).
Example —
D = rand(100);
D(5:10,10:20) = -999.999;
D(D == -999.999) = NaN;
figure
contour(D)
0 Comments
More Answers (0)
See Also
Categories
Find more on Contour Plots in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!