Connection with Parrot mini-drone at 192.168.3.1 failed

I am trying to deploy my code on Parrot Mambo, it builds and then this interface gets opened. But for running I get this error:

Connection with Parrot mini-drone at 192.168.3.1 failed, Ensure that drone is powered on and connected to the computer over Bluetooth

I have used the Keyboard input block in my code. Where is the problem?

I have checked my firewall and it is disabled.

[Srijith Vijay]

Did you try pinging the IP address to check if the Bluetooth connection is active?

[amin ya]

Yes It seems it is connected:

[Christopher Clark]

I would also be very interested in a fix for this...I am experiencing the same issue even though the command line shows the drone is connected.

[Javier Mauricio Zaraza Espinosa]

Did you find a way to fix it ?

Answer 1

[Vinod Hegde]

Hello,

To better understand the failure scenario you are experiencing, could you please provide the following details?

1. The version of MATLAB you are currently using.

2. The version of the Parrot Support Package installed on your system.

3. The operating system platform on which you are attempting to use the Simulink Parrot Support Package.

For troubleshooting purposes, I recommend revisiting the Parrot Hardware Setup screen to ensure that the drone is properly configured to run the model.

Please refer to the documentation for your specific version of MATLAB. For reference, here is the documentation page for the 23b release: [Set Up and Deploy on Parrot Minidrone](https://www.mathworks.com/help/supportpkg/parrot/ug/set-hardware-and-deploy-on-parrot-minidrone.html).

Thank you

[Benjamin Campbell]

I get the same thing, the ping test works in the set up of the drone, but then it fails when I press the start button. I am using the 2021a version of MATLAB, version 21.1.3 of the Parrot support package, and windows 10 operating system. Thank you!

Interestingly it does work when I run just the empty simulink parrot mambo template where it runs one or two motors at a time. But when I try to use the asbQuadcopter FlightControlSystem it says it can't connect via bluetooth - despite a successful build. Any help would be very appreciated! :)

[Vinod Hegde]

Hello Benjamin,

Can you try the following example "parrotMinidroneHoverStart": https://www.mathworks.com/help/supportpkg/parrot/ug/fly-a-parrot-minidrone-using-the-hover-simulink-model.html, and see if you are able to perform required operations.

Also attached here the link to other Parrot examples for reference that could be useful: Parrot Examples

Thank you.