Clear Filters
Clear Filters

How to make 1-D Look-Up Table block run repeatedly

13 views (last 30 days)
Hello everyone,
Now I'm looking for a way to interpretate a time related values as a signal into Simulink. The data is imported from .xml table and each value have a corresponding time value. My problem - that if i use Clock block - it would appear in the simulation only once. I tried to use reminder after devide, but in this case I can't change the time intervals between repeating the signal.
I'd like to know, how can I make 1-D Look-Up Table block run more then one time? My current solution would be attached. Capture.PNG
The constant value - last time data for this set.

Answers (1)

Chaitanya Mallela
Chaitanya Mallela on 30 Dec 2020
You can use Counter block before 1-D Look-Up Table block with Reset port enabled. When count reaches maximum value Reset port is enabled which restarts the Counter.

Products


Release

R2019a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!