Change the resonance frequency of a monopole.
2 views (last 30 days)
Show older comments
I want to design a monopole whose resonance frequency is 2477 MHz. I need the following dimensions:
- Height = 10 cm.
- Width = 0.00192 cm.
- Ground plane = 10X10cm.
Initially, modifying this conditions, if I plot the S11 parameter the resonance frequency is approximately 2200 MHz.
I am trying to cancel the reactive component of the impedance, but I can't move the frequency until 2477 MHz. I have tried to design a specific capacitor with the same purpose, but I have obtained the same result.
Can anyone help me? Thank you.
clear all; clc; close all; format long;
%% Simulation parameters
freq = 2477e6;
freqRange = 1500e6:1e6:3500e6;
speedOfLight = physconst('lightspeed');
lambda = speedOfLight/freq;
%% Antenna parameters.
ant = monopole;
ant.Height = 0.1;
ant.Width = 0.00192;
ant.GroundPlaneLength = 0.1;
ant.GroundPlaneWidth = 0.1;
%% Impedance
Z0 = 50;
ZL = impedance(ant,freq);
ZL_norm = ZL/Z0;
RL = real(ZL);
XL = imag(ZL);
%%
%Initial S11 parameter
figure('Name','Initial S11 parameter');
S = sparameters(ant,freqRange);
rfplot(S)
%% Reactive part cancellation.
RL_load = RL;
XL_load = 0;
load = lumpedElement('Impedance', complex(RL_load, XL_load), 'Location', [0 0 0]);
ant.Load = load;
figure('Name', 'S11 parameter after reactive part cancellation')
S = sparameters(ant,freqRange);
rfplot(S)
0 Comments
Answers (1)
Shashwat Bajpai
on 4 Oct 2019
To design an antenna at a particular frequency I would suggest using the design function. It auto populates the values of the dimensions of the antenna.
The link to documentation of design is provided below:
0 Comments
See Also
Categories
Find more on Analysis, Benchmarking, and Verification in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!