Problem connecting to Arduino Nano 3.0

I am trying to use an Arduino Nano 3.0 with MATLAB. I get the following error from trace:

         System wide configuration file is
         "C:\ProgramData\MATLAB\SupportPackages\R2019b\3P.instrset\arduinoide.instrset\hardware\tools\avr/etc/avrdude.conf"

         Using Port                    : COM5
         Using Programmer              : arduino
         Overriding Baud Rate          : 115200
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x7e
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x7e
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x7e
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x7e
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x7e
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x7e
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x7e
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x7e
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x7e
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x7e

avrdude done.  Thank you.

An error occurred while uploading the sketch

I can however, use the Arduino IDE to upload code and get serial info. Note that the Nano is probably a clone and shows as FTDI USB Serial in the COM port.

Answer 1

[Swapnil Sayan Saha]

Ok so I solved this in a weird way. Instead of specifying that the board is a Nano, I specified the board as a Pro Mini 328.

[Jason Wang]

Where can you find that option?

[Swapnil Sayan Saha]

a = arduino('COM5', 'ProMini328_5V', 'Libraries', 'I2C'); %check device port from device manager

[Jiayue Liang]

Thank you! I met the same problem. It really help me out!

[Cong Dong Ngoc Minh]

It was really help and worked properly.

Thank you so much Swapnil Sayan Saha!

[M.B]

@Jason Wang

Run

arduinosetup

In "choose board" select 'ProMini328_5V'. Then complete the setup.

You can now define the arduino object as:

myboard = arduino('COM3', 'ProMini328_5v');% choose the right COM port

[Oleksandr Denysenko]

It looks strange, but it works for me also. Thanks!

[Anchit Bhushan]

Thanks Swapnil, worked for me too

[Dave]

Many thanks.....worked for me :O)

[chheang]

that's work me (ProMini328_5V)

[Aravind]

thank you it works