Clear Filters
Clear Filters

How to run a simulation with powergui as continuous when the model involves a current measurement unit

18 views (last 30 days)
I have modelled a PV array interfaced with a DC DC boost converter circuit. I want to run the simulation with powergui as continuous. My model involves a voltage measurement unit and a current measurement unit, whose help documentation states that they work only when powergui is in phasor mode. I have however seen a model in the matlab help for powergui, with the same component but powergui set to continuous. How do I achieve the same ?
The model also involves a MOSFET switch which gets turned off if the powergui is phasor.
Rahul Choudhary
Rahul Choudhary on 14 Apr 2020
Edited: Rahul Choudhary on 14 Apr 2020
Documentation says if you set Simulation type to either phasor or Discrete phasor, it will enable a parameter in current measurement block which will allow you to set output signal type from your current measurement block.
However, the parameter 'Output signal' will not be available if you select Simulation type as continuous or discrete, and you will get instantaneous signal with respect to time as output.
Since you have switching devices in your model, avoid using phasor simulation mode.

Sign in to comment.

Answers (2)

Tony Lennon
Tony Lennon on 17 Apr 2020
See the comments for answers to this post

Amir Amsyar
Amir Amsyar on 14 Jan 2021
I used MATLAB 2020b version. I want to create a boost converter at the Simulink but I can't find powergui in library browser. When I search 'powergui' at the library browser in Simulink it shows 'no results found for powergui'. Somebody please help me:(


More Answers in the  Power Electronics Control


Find more on Electrical Sensors in Help Center and File Exchange

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!