lookup table error in simulink

54 views (last 30 days)
vishnuvardhan naidu tanga
vishnuvardhan naidu tanga on 29 May 2020
Commented: Sai Sri Pathuri on 2 Jun 2020
Hello I am trying to model a 2D lookup table in simulink. I am calling the break points and table data from workspace. When i run it it shows an error as "the number of dimensions specified by the 'Table data' parameter (1) must match the 'Number of table dimensions' parameter value (2)." but when I check the table dimensions are table data: 1x9000 and break point 1 : 1x9000 and break point 2: 1x9000 all are same. But still I am getting this error. Please guide me through it.

Answers (1)

Sai Sri Pathuri
Sai Sri Pathuri on 2 Jun 2020
Check whether you have set Number of table dimesions to 1, since your data is one-dimensional
  4 Comments
vishnuvardhan naidu tanga
yes i run the code. when i run the code the break points are updated from the data base. the error marks in break points are eliminated. But the system wont run because of the following error:
In block 'SH', the number of dimensions specified by the 'Table data' parameter (1) must match the 'Number of table dimensions' parameter value (2).
Sai Sri Pathuri
Sai Sri Pathuri on 2 Jun 2020
Set Number of table dimensions (I highlighted it in above screenshot) to 1 in the dialog box, because your input is one-dimensional

Sign in to comment.

Categories

Find more on Simulink Functions in Help Center and File Exchange

Products

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!