If Action Block that create a stairstep signal in simulink
1 view (last 30 days)
Show older comments
Alberto Mora
on 1 Jun 2020
Answered: Fangjun Jiang
on 1 Jun 2020
Hello,
I have two questions:
- I use a If Block to "cut" the signal and not perform some operations (not depicted below). Is it the right approach to use a "If Block" for interupt the signal and don't allow to perform some tasks by the model?
- However I notice that after the "If Block" the signal became discrete (see the plot below, where you can see a stairstep plot), even if before the "If Block" the signal was continous (see the plot below, where you can see a continous plot). How to convert again the discrete signal into a continous?
0 Comments
Accepted Answer
Fangjun Jiang
on 1 Jun 2020
The "sample time" of the Constant block might have been set as "1" second.
0 Comments
More Answers (0)
See Also
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!