How can I generate Arbitrary PWM with specific pattern on C2834x DSP?

2 views (last 30 days)
Hello.
I am trying to generate a signal with same width as in figure on 2834x DSP using c2000 support package. Unfortunately ePWm modules CANNOT be used and the only option that I have got are the GPIO pins. I tried repeating sequence stair block and it worked fine When sampling time was 1/(3*140000). However, when decreasing the samplig time to 1/(12*140000), the PWM pin behaviour becomes awkward and the pins is either always ON r always OFF. I tried modifing the step size to be lower value 1/(120*140000), but it also gave this awkward behaviour.

Answers (1)

Venkatesh Chilapur
Venkatesh Chilapur on 2 Jul 2020
Hi,
Here is an idea:
I set the solver to 0.01step time in above case.
HTH,
Regards,
Venkatesh C
  1 Comment
Ahmed Khamis
Ahmed Khamis on 14 Jul 2020
This doesn't work, I even checked the output of "rem" block, it is zero all the time. Anyways, I doubt that this logic would output a signal with same pattern shown in scope in my original question.

Sign in to comment.

Tags

Products

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!