How to change Simscape Multibody model parameter during simulation
1 view (last 30 days)
Show older comments
My multibody modle shall change length,mass,inertia of the rod during simulation. Is this supported in the Simulink
1 Comment
Ameer Hamza
on 20 Jun 2020
I don't think it is supported yet. I tried it some time ago, but simscape blocks didn't respond to that. Simsapce blocks are different as compared to normal Simulink blocks, so I guess there are some implementation differences. You may try it using event-listeners and set_param() as given here: https://blogs.mathworks.com/simulink/2013/01/25/accessing-block-data-during-a-simulation/.
Answers (1)
Steve Miller
on 7 Jun 2021
Hi Mark,
There are variable solid blocks in Simscape Multibody.
- https://www.mathworks.com/help/physmod/sm/ref/variablebricksolid.html
- https://www.mathworks.com/help/physmod/sm/ref/variablecylindricalsolid.html
- https://www.mathworks.com/help/physmod/sm/ref/variablesphericalsolid.html
Their properties can vary during simulation.
You can also motion actuate a joint to change the separation of two frames during simulation.
--Steve
0 Comments
See Also
Categories
Find more on Assembly in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!