porting the matlab code to TI DSP

I have built a communication code in matlab. i want to port this code to TI DSP 64X. Can i use matlab coder and completely convert to C code and port it on to DSP. Dos MATLAB coder support all the matlab functions?

Answer 1

[Walter Roberson]

MATLAB Coder does not support all MATLAB features.

https://www.mathworks.com/help/coder/ug/matlab-language-features-supported-for-code-generation.html

https://www.mathworks.com/help/coder/ug/functions-supported-for-code-generation-categorical-list.html

[Mark Phil]

We want to use OMAPL138 processor. I want to build modulation/demodulation blocks with 700 kbps data rate. Should i implement my signal processing blocks in the ARM or DSP side? which is better? 2. Can i build matlab code and convert to C/C++ using matlab embedded coder and port it on to DSP. or Is there any better way to do it?

[Walter Roberson]

I note that the OMAP-L138 is C674x and in particular one source says TMS320C6748 . This would not appear to be the same as TI DSP 64X that you asked about in your original question ?

[Walter Roberson]

My expectation would be that you could get higher data rate with the modulation / demodulation on the DSP side.

It looks like Embedded Coder does not have direct support for C6000 series; see https://www.mathworks.com/hardware-support/texas-instruments.html

Someone's steps are shown at https://e2e.ti.com/support/tools/ccs/f/81/t/734740?Compiler-how-to-make-code-generation-with-OMAP-L138-Experimenter-Kit-CCSv5-5-and-MATLAB-SIMULINK

Note: I have never used MATLAB Coder or Simulink Coder or Embedded Coder or any of the TI DSPs.