How can I use the simplfied synchronous generator in SimPowersystems in a phasor simulation type?
1 view (last 30 days)
Show older comments
I am attempting to use a simplified synchronous generator from the Simpowersystems lab in modeling a distribution system for my Smartgrid class. I want to sue this generator as the power source becacause it will allow the sutdents to develop a control system for its output voltage. Ultimately we wouild like to model the behavior of the system over a 24 hour period and incorporate changing loads and renewable energy sources. Unless I can run in phsor mode, the simulation time and memory required will be prohibitive. When I add the generator to the distribution network and run in continuous mode over a short period (10 seconds) I get the expected voltages in the circuit. When I run the simulation in phasor mode, I get absurd values, like 3e108. what is going on with this model block and how do I correct it? Are their example models that use this block in phasor mode that I can look at?
0 Comments
Answers (1)
Joel Van Sickel
on 11 Dec 2020
power_simplealt can be switched to phasor mode, there will be a small perturbance at start, but then it works.
0 Comments
See Also
Categories
Find more on Electrical Sensors in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!