Dan81

Last seen: Today | Active since 2023

Followers: 0 Following: 0

Statistics

Feeds

Question

Can a Truth table be imported as a single requirement using Requirements Toolbox?
Hi, I am familiar with Simulink's Requirements Toolbox and the process of importing requirements via Excel or Word. However, o...

2 months ago | 0 answers | 0

0

answers

Question

How to continually clock in data during a simulation within Simulink
Hi, I am experimenting within Simulink, and I wish to be able to run a simulation while clocking in input data several times du...

5 months ago | 3 answers | 0

3

answers

Question

I would like to quantize a Sinewave correctly, and identify where the issues is with my code
Hi, With the code below, I am trying to Quantize the Sinewave by varying the quantity of bits from 16-bits down via Bit Shiftin...

5 months ago | 1 answer | 0

1

answer

Question

Convert vector of numeric values into a vector of equivalent 8-bit 'int8' binary values
Hi, I am trying to convert a 1x4 numeric vector into the equivalent 8-bit binary 'int8' value which is also a 1x4 vector, howev...

5 months ago | 1 answer | 0

1

answer

Answered
Unsupported data conversion when importing Excel file into Signal Editor
The Signal Editor does not accept ufix3 data types and it will also not accept Type: ufix2 as a numeric value. Using ufix2 in th...

6 months ago | 0

| accepted

Question

Unsupported data conversion when importing Excel file into Signal Editor
Hi, I have created a test harness of a subsystem I intend on testing. I have created a test sequence using Excel and I am tryin...

6 months ago | 2 answers | 0

2

answers

Question

Why does the Simulink.VariantExpression object in R2023b does not seem to be compatible with the Simulink.Variant object in R2017b
Our company uses the same Simulink model in MATLAB R2017b and R2023b which contains variant subsystems. Unfortunatley we need to...

8 months ago | 1 answer | 0

1

answer

Question

Delay balancing error using R2023b, but have not experienced this in R2017b
Hello, I have currenlty updated my Simulink to R2023b from R2017b. In the past I have been abe to successfully build my models ...

1 year ago | 1 answer | 0

1

answer