Saurav Shandilya

MathWorks

Last seen: 13 days ago | Active since 2024

Followers: 0 Following: 0

I am Software Engineer at MathWorks. I work actively on developing embedded system software to enable use of MCU within Simulink model. Disclaimer: All opinions I express on this forum are my own and not representative of MathWorks.

Programming Languages:
Python, C++, C, MATLAB, Arduino, Shell, Assembly
Spoken Languages:
English, Hindi
Pronouns:
He/him
Professional Interests:
Embedded Systems

Statistics

View badges

Feeds

Answered
Issue regarding Connect STM32G4xx controller with Simulink
Hi @Vijay Chaudhari Can you refere to this answer thread. STM32 XCP via CAN bus - "Parser::describeSymbol xcpDummyDoubleVari...

13 days ago | 0

Answered
STM32 XCP via CAN bus - "Parser::describeSymbol xcpDummyDoubleVariable is not a global variable" error
Hi @Luka, The issue is most likely because compiler optimization would be removing xcpDummyDoubleVariable as part of optimiza...

20 days ago | 0

Answered
The following error occurred during deployment to your hardware board: No STM32 MCU connected.
Hi @SUSU, Refer to the solution suggested in PIL question: having problem connecting to STM32 board - MATLAB Answers - MATL...

3 months ago | 0

Answered
PIL question: having problem connecting to STM32 board
Hi @YE Most likely the board detection issue will be due to due to ST-Link version on board. You may need to update ST-Link f...

3 months ago | 0

Answered
Simulink cannot read my STM32 NUCLEO-H753ZI Hardware
Hi @Ali, The steps mentioned for U545 was due to the reason that STM32CubeMX-6.4.0 does not support this board selection and ...

11 months ago | 0

Answered
Error in Simulink: No STM32 MCU Connected
Hi @Ali As you have not mentioned details about products and support package version you are using, I am assuming that you ar...

12 months ago | 0

Answered
STM32F4xx SPI Block Error
Hi @behnam sanaei, The issue is not getting reproduced by just using SPI transmit block. It would be great if you can contact...

1 year ago | 0

Answered
STM32 NUCLEO fatal error: No such file or directory #include "main.h"
Hi @Anton Sychugov, Based on screenshot, issue seems to be Build Toolchain. You are using MingGW64 which is primarily used to...

1 year ago | 0

Answered
the MS5611 sensor, with smt32f411 card
Hi @jefferson arnobis, You can use I2C controller read and write block from Embedded Coder Support Package for STMicroelectro...

1 year ago | 0

Answered
Arduino UNO R4 Minima support?
Hi @d mc, Currently MATLAB Support Package for Arduino Hardware is not compatible with Uno R4 boards. You can refer belo...

1 year ago | 1

Answered
Can etas inca calibration software calibrate stm32 programs developed on simulink, by using a serial device?
Hi @昕彤, As per INCA documentation (Details - XCP-IP - ETAS), there is support for XCP on CAN and Ethernet. Therefore XCP on S...

1 year ago | 0