photo

Ahmed Desoky


Last seen: 6 months ago |  Active since 2016

Followers: 0   Following: 0

Statistics

  • Revival Level 1
  • First Answer

View badges

Feeds

View by

Question


How do I perform PID controller from error by using matlab script?
I want to change the PID that is shown in this figure to matlab script I am tring to use PID=Kp*ev + Ki * integral(ev)+ Kd ...

5 years ago | 0 answers | 0

0

answers

Answered
Error while importing the excel file into signal builder
I have the same problem on 2016a. did you get a solution?

7 years ago | 0

Question


How to select some element from matrix by simulink?
I want to get all element except -1 By Simulink For example: u2 = [46.15 ; -22.5 ; -1 ; ...

8 years ago | 0 answers | 0

0

answers

Question


How to find the index of the first non-zero element in a 2-D array in simulink?
I want to find the index of the first non-zero element in a 2-D array in simulink, just like the way that 'find' command in ...

8 years ago | 0 answers | 1

0

answers

Question


How to save video and images from usb webcam in Raspberry Pi by simulink?
I had connected the usb webcam to Raspberry Pi. I loaded the Simulink model that mention below onto Raspberry Pi board from the...

8 years ago | 0 answers | 1

0

answers

Question


How to execute the Simulink model from Raspberry Pi?
I have built a Simulink model consisting of three blocks (Pulse generator + Data Type Conversion + GPIO Write) to flash a LED. ...

8 years ago | 0 answers | 0

0

answers

Question


How to start Simulink model on Raspberry Pi automatically on startup?
I have built a Simulink model consisting of three blocks (Pulse generator + Data Type Conversion + GPIO Write) to flash a LED. ...

8 years ago | 1 answer | 0

1

answer

Question


How to do Simulink model run in Raspberry Pi after power on (booting) as standalone ?
I build a Simulink model to control Dc motor, load into the board, stop Simulink model and plug out the power and Ethernet cable...

9 years ago | 0 answers | 0

0

answers