photo

S POORNIMA


Last seen: 1 year ago |  Active since 2016

Followers: 0   Following: 0

Statistics

  • Explorer
  • First Review

View badges

Feeds

View by

Question


rms plot of voltage sag during faults
I want to get rms plot for a fault voltage like this using simulink. kindly help.

3 years ago | 0 answers | 0

0

answers

Question


iam trying to simulate a nonlinear transformer of simscape. iam getting a mismatch error in current and flux vector. but i have verified it many times . please help me to sort this
iam trying to simulate a nonlinear transformer of simscape. iam getting a mismatch error in current and flux vector. but i have...

6 years ago | 0 answers | 0

0

answers

Answered
I am trying to simulate a voltage transformer in simulink. Iam getting a spike voltage at the beginning of the secondary voltage (rated 110V but getting 6000V). how to prevent this
Sir, I have attached the model. if i enable hysteresis, Instead of 6000v spike iam getting 50v normal sine waveform. if i disabl...

6 years ago | 0

Question


I want to simulate a n channel JFET(UJN1208K) in simulink. but Iam not getting its small signal parameters from the datasheet. can you please help to give the simulation procedure
I want to simulate a n channel JFET(UJN1208K) in simulink. but Iam not getting its small signal parameters from the datasheet. c...

6 years ago | 0 answers | 0

0

answers

Question


I am trying to simulate a voltage transformer in simulink. Iam getting a spike voltage at the beginning of the secondary voltage (rated 110V but getting 6000V). how to prevent this
I am trying to simulate a voltage transformer in simulink. Iam getting a spike voltage at the beginning of the secondary voltage...

6 years ago | 1 answer | 0

1

answer

Question


Current vector, i and Magnetic flux vector, phi must be of the same size In elec.passive.nonlinear_transformer
I WANT TO SIMULATE A VOLTAGE TRANSFORMER OF 50VA, 11KV/110V. WHEN I ENTER THE CURRENT ANS MAGNETIC FLUX VECTOR, the error says t...

7 years ago | 0 answers | 0

0

answers

Question


How to interface Pspice and Matlab simulink? How to get SLPS software to interface? If not by SLPS software, what else can be used to interface?
How to interface Pspice and Matlab simulink? How to get SLPS software to interface? Is there any specific website to download t...

7 years ago | 0 answers | 0

0

answers

Question


How to get memristor block to be used in simulink? If i get is it possible to use in Matlab2013R version?
I want to use memristor emulator circuit in my models. How to get memristor emulator block to be used in simulink? If i get is i...

7 years ago | 0 answers | 0

0

answers

Question


How to plot Poincare map and Bifurcation diagrams of ferrosonance
I doing research in Ferroresonance. Please help me to learn to plot Poincare map and Bifurcation diagrams of ferrosonance.

8 years ago | 1 answer | 0

1

answer