AD936x Receiver Transmitter blocks missing in Simulink library

Hello all,

I have installed communication tool box suppoprt package for Xilinx Zynq-base radio, I can open the corresponding AD936x Receiver and transmitter blocks by running an example("zynqRadioQPSKRxAD9361AD9364SL"). why can't I find them in my Simulink library?

Any advice would be appreciated.

Kind Regards

Arash

Answer 1

[Bharath Venkataraman]

Running the command "which zynqRadioQPSKRxAD9361AD9364SL" should show you where the Simulink model lives in your installation. This is an example model, so it is not in your Simulink Library Browser.

[Arash Jafari]

Hello Bharath,

Thank you very much for your email.

Do I need to run the example everytime and copy the corresponding TX and RX AD936x to my simulink model in order to be able to communicate with the board.

I would be grateful if you let me know how to configure the AD-FMCOMMS3 in Simulink to use external Clock and external LO instead of the internal ones.

Kind Regards

Arash

[Lakshmi Bugide]

Hi Arash,

You can find info about how you can access the AD936x Transmitter/Receiver blocks at https://in.mathworks.com/support/bugreports/2571397.

No, you no need to copy the corresponding TX and RX AD936x blocks to your simulink model everytime in order to communicate with the board.

The AD-FMCOMMS3 in Simulink supports only the internal clock options only.

Thanks,

Lakshmi

[Arash Jafari]

Dear Lakshmi,

Thank you for the reply, That was the correct answer to my question!

Kind Regards

Arash