simdriveline (Basic motion torque and forces modelling). Not getting simulation of two spinning inertias
1 view (last 30 days)
Show older comments
When I am trying to build the subsystems for Motion sensor (base and follower) and I am not getting the connection between the mechanical ports and physical signals correctly. I tried all the possibilities but its not happening. Please help me to solve that.
Thank you in advance.
1 Comment
Sebastian Castro
on 17 Aug 2015
Do you have a screenshot of your model and any results/error messages to share with us?
Answers (1)
Steve Miller
on 4 Aug 2020
This example shows a common use of the motion sensor blocks:
The distance between R and C is output at port P. You define the initial offset between these two ports in the Motion Sensor block. You connect the Phyiscal Signal to Simulink Converter block to the sensor in order to get a Simulink signal that you can connect to a Scope or a control system.
0 Comments
See Also
Categories
Find more on Simscape Driveline in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!