Community Profile

photo

Anush


Last seen: 9 months ago Active since 2023

Statistics

  • Knowledgeable Level 1
  • First Answer

View badges

Content Feed

View by

Answered
issue with displaying the changing values on scope block via MATLAB function block
Hello Mehreen, If you are experiencing issues with displaying the changing values of the temperature in a Simulink model while ...

9 months ago | 0

Answered
Cannot run and debug Simulink model on some LAUNCHXL-F28379D boards
Hello Shreyas, The above issue may be because of several reasons including port access permissions and physical connection issu...

9 months ago | 0

Answered
How can I interface my Texas Instrument DSP with available CAN communication through simulink
Hello Ashik, One effective approach to interface your TIF28379D board with CAN protocol through simulink is to make use of the ...

9 months ago | 0

Answered
How to read I2C from chip that does not use traditional registers but commands
Hello Johannes, You can make use of the AD5272 Datasheet to come up with a suitable workflow for the read operation. The data...

9 months ago | 0

| accepted

Answered
STM Nucleo real-time in external mode or connected IO
Hi Daniil, You can do real-time parameter tuning and logging using external mode with STM32 F103RB nucleo board. You need to i...

9 months ago | 0

Answered
how to convert .mat file to .nrrd file with correct size
Hello, Instead of the following line of code: img = load('outVol.mat'); You need to access the outVol field of the img struct...

10 months ago | 0

| accepted

Answered
How do I compute the p-value of the highest r-value from the function [c,lags]=xcorr(A,B)?
Hello Sammy, To compute the p-value of the highest correlation value obtained from the xcorr() function, you can do the followi...

10 months ago | 1

Answered
Saving an arabic string into a .txt file makes it all distorted
Hello Charbel, For the fwrite() function, make the following change: fwrite(fileID, stego, 'char', 'n'); This specifies that ...

10 months ago | 0

Answered
Top left cell in uitable
Hi Abhishek, There doesn't seem to be a direct way to achieve it. However, you can make use of 'Labels' to do the task. Followi...

10 months ago | 0

Answered
STM32 code generation
Hi Vasu, The problem actually exists in the configuration in STM32CubeMX and not in the target link file. Enable the 'Do not g...

10 months ago | 0